Adversaries may communicate using publish/subscribe (pub/sub) application layer protocols to avoid detection/network filtering by blending in with existing traffic. Commands to the remote system, and often the results of those commands, will be embedded within the protocol traffic between the client and broker. Protocols such as MQTT are widely used in Internet-of-Things (IoT) and operational technology environments where devices are resource constrained and there is limited or unreliable network bandwidth. The protocol follows a publish/subscribe design, with message distribution managed by a centralized broker. Publishers categorize their messages by topics, while subscribers receive messages according to their subscribed topics. An adversary may abuse publish/subscribe protocols to communicate with systems under their control from behind a message broker while also blending in with normal, expected traffic.
Use network appliances to filter ingress or egress traffic and perform protocol-based filtering. Configure software on endpoints to filter network traffic. Perform inline allow/denylisting of network messages based on the application layer (OSI Layer 7) protocol, especially for automation protocols. Application allowlists are beneficial when there are well-defined communication sequences, types, rates, or patterns needed during expected system operations. Application denylists may be needed if all acceptable communication sequences cannot be defined, but instead a set of known malicious uses can be denied (e.g., excessive communication attempts, shutdown messages, invalid commands). Devices performing these functions are often referred to as deep-packet inspection (DPI) firewalls, context-aware firewalls, or firewalls blocking specific automation/SCADA protocol aware firewalls. (Citation: Centre for the Protection of National Infrastructure February 2005)
M0931Network Intrusion PreventionUse intrusion detection signatures to block traffic at network boundaries. In industrial control environments, network intrusion prevention should be configured so it will not disrupt protocols and communications responsible for real-time functions related to control or safety.
MITRE ATT&CK® is a registered trademark of The MITRE Corporation. © 2026 The MITRE Corporation. This work is reproduced and distributed with the permission of The MITRE Corporation.